home 
wiki
wiki
Layer2Assumptions
802.11 specifies two principle modes of operation, IBSS and BSS. The reason this is important is because it can change the way that the layer two connectivity appears to hosts.To begin, have a look at this
explanation.If the host has an interface running in IBSS mode, then it will be able to contact a subset of other hosts within the IBSS domain. For those hosts that are reachable, the network will look as if it is a broadcast domain (ie. like ethernet, not like ATM). For those hosts that aren't in range, it simply will not be able to address. However for each individual host, the set of reachable and unreachable hosts will differ. The implications of this on IP networking in IBSS mode are explained below.
If the host has an interface in BSS mode though, the point control function ensures that each host in the BSS domain can hear all other hosts within the same domain. This way everyone has the same set of reachable hosts.
So if a host is operating in BSS mode, the layer two looks the same as any other broadcast layer two medium, e.g. the most common, 802.3 ethernet. You can assign a subnet to the interface, and can be certain that if an IP within that subnet is active on another interface, that it will be addressable at layer two by every other host on the same subnet. In other words, if host A needs to talk to host B, A can use ARP (address resolution protocol) to discover B's hardware address, and then proceed to talk directly.
In contrast, in IBSS mode, if you allocate a subnet to the interface, you cannot be certain that you will be able to address other hosts on the same subnet at layer two. You may need to rely on another node/s to forward your frames/packets in order for them to reach the destination. However if you decide that this is no good, and try to assign a subnetwork for the hosts that are reachable at layer two, then in general, the hosts in the IBSS domain will be unable to agree on who is in the set and who is out. This implies that you need several sets, possibly one per host - so you have a large number of IP addresses assigned to the one interface, sub-interfaces if you like. Additionally, every time another host is added to the IBSS domain, these networks change, so configurations must be changed as well.
Version 2 (old) modified Mon, 26 Jul 2021 12:49:29 +0000 by graybeard
[EditText] [Spelling] [Current] [Raw] [Code] [Diff] [Subscribe] [VersionHistory] [Revert] [Delete] [RecentChanges]